Kia Sorento: Inspection
| 1. |
Turn ignition switch OFF.
|
| 2. |
Remove the air duct.
(Refer to Engine Mechanical System - "Air cleaner")
|
| 3. |
Disconnect the solenoid valve connector (A).
|
| 4. |
Measure resistance between sensor signal terminal and sensor ground
terminal.
|
| 5. |
Check that the resistance is within the specification.
|
Circuit Diagram
RemovalReceiver-Drier Replacement
1.
Remove the condenser.
2.
Remove the cap (B) on the bottom of the condenser with a L wrench
(A).
Tight ...
Ignition Coil Installation
1.
Install in the reverse order of removal.
Ignition coil installation bolts:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 Ib-ft)
...
Using the iPod® device
Some iPod® models may not support communication protocol and files may not
properly play. Supported iPod® models: iPhone® 3GS/4 iPod® touch 1st~4th generation
iPod® nano 1st~6th generation ...