Kia Optima Manuals

Kia Sorento: Valve Body Installation - Hydraulic System - Automatic Transaxle System - Kia Sorento XM 2011-2026 Service ManualKia Sorento: Valve Body Installation

Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Automatic Transaxle System / Hydraulic System / Valve Body Installation

1.
Install in the reverse order of removal.
  
•
Adding coolant.
(Refer to Engine Mechanical System - "Coolant")
•
Adding Automatic Transaxle Fluid(ATF).
(Refer to Hydraulic System - "Fluid")
•
Perform Transaxle Control Module(TCM) learning after replacing the valve body to prevent slow transaxle response, jerky acceleration and jerky startup.
(Refer to Automatic Transaxle Control System - "Repair procedures")
Valve Body Removal
1. Remove the air duct. (Refer to Engine Mechanical System - "Air cleaner") 2. Remove the battery and the battery tray. ...

ATF Warmer Description
The ATF warmer is mounted on the valve body cover to reduce oil viscosity friction by increasing oil temperature under cold condition, which in turn improves fuel efficiency. It is serial mou ...

See also:

Antenna Coil Removal
1. Disconnect the negative (-) battery terminal. 2. Remove the steering column upper and lower shrouds (A). 3. ...

In-car Sensor Inspection
1. Turn the ignition switch ON. 2. Blow air with changing temperature into the in-car sensor air inlet. Measure the sensor resistance betwe ...

Description
Emissions Control System consists of three major systems. • Crankcase Emission Control System prevents blow-by gas from releasing into the atmosphere. This system recycl ...

Categories

Copyright www.ksmanual.com 2014-2026