Kia Optima Manuals

Kia Sorento: High Pressure Fuel Pump Removal - Fuel Delivery System - Engine Control / Fuel System - Kia Sorento XM 2011-2026 Service ManualKia Sorento: High Pressure Fuel Pump Removal

Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Engine Control / Fuel System / Fuel Delivery System / High Pressure Fuel Pump Removal

  
In case of removing the high pressure fuel pump, high pressure fuel pipe, delivery pipe, and injector, there may be injury caused by leakage of the high pressure fuel. So don’t do any repair work right after engine stops.
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Release the residual pressure in fuel line.
(Refer to the Fuel Delivery System - Repair Procedures - "Release Residual Pressure in Fuel Line")
  
When removing the fuel pump fuse, a Diagnostic Trouble Code (DTC) may occur.
Delete the code with the GDS after completion of “Release Residual Pressure in Fuel Line” work.
3.
Remove the air cleaner and the air intake hose
(Refer to Engine Mechanical System - “Intake And Exhaust System”)
4.
Disconnect the fuel pressure control valve connector (A).
5.
Remove the ignition coil (B).
6.
Disconnect the fuel feed tube quick-connector (A).
7.
Remove the high pressure fuel pipe.
(1)
Remove the installation nut (B) from the high pressure fuel pump with the special service tool [SST No.: 09314-3Q100]
(2)
Remove the installation nut (C) from the delivery pipe with the special service tool [SST No.: 09314-3Q100]
(3)
Remove the purge control solenoid valve.
(Refer to Engine Control Systme - “PCSV”)
(4)
Remove the function block (D), and then remove the high pressure fuel pipe.
8.
Remove the installation bolts (E), and then remove the high pressure fuel pump from the cylinder head assembly.
  
Unscrew in turn the two bolts in small step (0.5 turns). In case of fully unscrewing one of the two bolts with the other bolt installed, the housing surface of the cylinder head may be broken because of tension of the pump spring.

Delivery Pipe Installation
   • Install the component with the specified torques. ...

High Pressure Fuel Pump Installation
   • Be sure to check the low pressure fuel hose quick-connector (A) is completely connec ...

See also:

Transaxle Oil Temperature Sensor Description
Transaxle Oil Temperature Sensor(OTS) monitors the automatic transaxle fluid's temperature and conveys the readings to TCM. It is an Negativen Thermal Coefficient(NTC) sensor whose resist ...

Smart key unit Installation
Smart Key Unit 1. Install the smart key unit. 2. Install the smart key unit mounting bolt and nut, and then connect the connector. ...

Special Service Tools
Tool (Number and Name) IIIustration Use 09546-26000 Strut spring compressor Compression of coil spring ...

Categories

Copyright www.ksmanual.com 2014-2026