Kia Sorento: Signal Waveform

The three waveforms below are taken from the #1 and #4 injectors. The top waveform is from the high side (feed side) of the #1 and #4 injectors, while the middle waveform is from the low side (ground side) of the #1 injector and the bottom waveform is from the low side of the #4 injector.

The middle waveform is the same as the top waveform because there is no ground for the circuit. With no current flowing in the circuit, the #1 injector is not energized and fuel does not flow.

The bottom waveform shows that ground is supplied and there is a voltage drop across the #4 injector. With current flowing in the circuit, the #4 injector is energized and fuel flows.

Specification

Item Specification Coil Resistance (Ω) 1.18 ~ 1.31 [20°C(68°F)] ...

Circuit Diagram

...

See also:

Auto Defogging Actuator Inspection
1. Turn the ignition switch OFF. 2. Disconnect the auto defogging connector. 3. Verify that the auto defoggin ...

Troubleshooting
Problem Possible cause Solution Not pairing Bluetooth device of Car is not discoverable mode Enter Bluetooth pairing (searching) mode Userâ ...

Components Location
1. Front axle 2. Front lower arm 3. Drive shaft 4. Sub frame 5. Stabilizer bar 6. Steering gearbox 7. Stabilizer link 8. Front strut assembly ...