Kia Sorento: Rear Driveshaft Inspection
Second Generation XM (2011-2025) / Kia Sorento XM 2011-2025 Service Manual / Driveshaft and axle / Rear Driveshaft Assembly / Rear Driveshaft Inspection
| 1. |
Check the driveshaft boots for damage and deterioration.
|
| 2. |
Check the ball joint for wear and damage.
|
| 3. |
Check the splines for wear and damage.
|
| 4. |
Check the driveshaft for cracks and wears.
|
| 5. |
Check the TJ outer race, inner race, cage and balls for rust or
damage.
|
| 6. |
Check for water, foreign matter, or rust in the BJ boot.
|
Rear Driveshaft Removal and Installation
1.
Remove the rear wheel and tire (A) from rear hub.
Tightening torque:
88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft)
...
Rear Driveshaft Disassembly
•
Do not disassemble the BJ assembly.
•
...
See also:
Checking the engine oil level
1. Be sure the vehicle is on level ground.
2. Start the engine and allow it to reach normal operating temperature.
3. Turn the engine off and wait for a few minutes (about 5 minutes) for the oil
...
Parking Brake Pedal Assembly Removal
1.
Turn ignition switch OFF and disconnect the negative (-) battery
cable.
2.
Remove the crash pad lower panel.
(Refer to Body - & ...
Input/Output Specification
Connector Pin Lay Out
IMS input/output pin information
No
Signal Name
I/O
Contents
Remark
A1
-
-
-
...
Categories
- Home
- First Generation
- Second Generation
- Kia Sorento XM 2011-2025 Owners Manual
- Kia Sorento XM 2011-2025 Service Manual
Copyright www.ksmanual.com 2014-2025