Kia Optima Manuals

Kia Sorento: Removal - Rail Pressure Sensor (RPS) - Engine Control System - Engine Control / Fuel System - Kia Sorento XM 2011-2026 Service ManualKia Sorento: Removal

Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Engine Control / Fuel System / Engine Control System / Rail Pressure Sensor (RPS) / Removal

1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Release the residual pressure in fuel line.
(Refer to the Fuel Delivery System - Repair Procedures - "Release Residual Pressure in Fuel Line")
  
When removing the fuel pump relay, a Diagnostic Trouble Code (DTC) may occur. Delete the code with the GDS after completion of “Release Residual Pressure in Fuel Line” work.
3.
Remove the intake manifold.
(Refer to Engine Mechanical System - "Intake Manifold")
4.
Disconnect the rail pressure sensor connector (A), and then remove the sensor (B) from the delivery pipe.
Inspection
1. Connect the GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the RPS at idle and various engine speed. ...

Installation
   • Install the component with the specified torques. • ...

See also:

Power Tailgate Unit Block Diagram
...

Specifications
Item Specification Master cylinder • Type • I.D. mm(in) ...

SRS Control Module (SRSCM) Installation
1. Remove the ignition key from the vehicle. 2. Disconnect the battery negative cable and wait for at least three minutes before beginning ...

Categories

Copyright www.ksmanual.com 2014-2026