Kia Sorento: Removal
| 1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
| 2. |
Remove the intake manifold.
(Refer to Engine Mechanical System - "Intake Manifold")
|
| 3. |
Disconnect the injector connector (A).
|
| 4. |
Remove the installation bolt (B), and then remove the sensor from
the cylinder block.
|
Circuit Diagram
...
Installation
•
Install the component with the specified torques.
•
...
See also:
Direct Electro Hydraulic Actuator Coupling Inspection
All units are filled up with coupling fluid (ultra-low viscosity
ATF) prior to shipping. Inspection, fill-up, and replac ...
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Turn the ignition switch ON.
3.
Measure the output volt ...
Voice Command List
Common Commands:
These commands can be used in most operations. (However a few commands may not
be available during certain operations)
FM/AM radio commands:
Commands available during FM, ...
Categories
- Home
- First Generation
- Second Generation
- Kia Sorento XM 2011-2025 Owners Manual
- Kia Sorento XM 2011-2025 Service Manual
Copyright www.ksmanual.com 2014-2025