Kia Sorento: Removal - Engine Coolant Temperature Sensor (ECTS) - Engine Control System - Engine Control / Fuel System - Kia Sorento XM 2011-2024 Service ManualKia Sorento: Removal

Second Generation XM (2011-2024) / Kia Sorento XM 2011-2024 Service Manual / Engine Control / Fuel System / Engine Control System / Engine Coolant Temperature Sensor (ECTS) / Removal

1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Disconnect the engine coolant temperature sensor connector (A).

3.
Remove the spring clip (A), and then pull the sensor from the water temperature control assembly.

  
Note that engine coolant may be flowed out from the water temperature control assembly when removing the sensor.
Inspection
1. Turn the ignition switch OFF. 2. Remove the ECTS (Refer to "Removal"). 3. After immersing the ther ...

Installation
   • Note that internal damage may occur when the component is dropped. If the component ...

See also:

Seat Belt Buckle Switch (BS) Removal
1. Disconnect the battery negative cable, and wait for at least three minutes before beginning work. 2. Remove the front seat assembly. (Re ...

Tightening Torques
Item N.m kgf.m lb-ft Ignition coil installation bolt 9.8 ~ 11.8 1.0 ~ 1.2 7.2 ~ 8.7 Spark plug installation 14.7 ~ 24. ...

Side Impact Sensor (SIS) Removal
Front Side Impact Sensor    • Removal of the airbag must be performed according to ...

Copyright © www.ksmanual.com 2014-2024