Kia Sorento: Adjustment
After replacing ETC module or ECM, the ETC adaptive value must be reset
/ relearned according to the following procedure.
| 1. |
Check DTC(s) and clear if exist.
|
| 2. |
Select "Data Treatment", to reset the ETC adaptive value.
|
| 3. |
Select "Resetting adaptive values".
|
| 4. |
Select "Reset", then wait 10 seconds after turning ignition key
off (Relay OFF).
|
| 5. |
Wait for 5 seconds after turning the ignition ON (ETC adaptive
value relearn).
If equipped with Button Engine Start System, push the engine start/stop
button 2 times without depressing the brake pedal. This will allow the
ECM to automatically learn the throttle valve position; then wait for
approximately 5 seconds.
|
| 6. |
Start engine.
|
| 7. |
Recheck DTC(s).
|
Installation
•
Install the component with the specified torques.
•
...
See also:
Dynamic Damper Installation
1.
Apply soap powder on the shaft to prevent being damaged between
the shaft spline and the dynamic damper.
2.
Install the dynamic damper.
...
Condenser Replacement
1.
Recover the refrigerant with a recovery/recycling/charging station.
2.
Disconnect the negative (-) battery terminal.
3.
...
Rear Hub - Carrier Inspection
1.
Check the hub for cracks and the splines for wear.
2.
Check the rear axle carrier for cracks.
...
Categories
- Home
- First Generation
- Second Generation
- Kia Sorento XM 2011-2026 Owners Manual
- Kia Sorento XM 2011-2026 Service Manual
Copyright www.ksmanual.com 2014-2026