Kia Sorento: Fuel Tank Air Filter Removal - Evaporative Emission Control System - Emission Control System - Kia Sorento XM 2011-2026 Service ManualKia Sorento: Fuel Tank Air Filter Removal

Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Emission Control System / Evaporative Emission Control System / Fuel Tank Air Filter Removal

1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Lift the vehicle.
3.
Disconnect the canister close valve connector (A).
4.
Disconnect the ventilation tube quick-connector (B) from the fuel tank air filter and canister close valve.

5.
Disconnect the vapor tube quick-connector (A).
6.
Remove the canister assembly bracket (D) after removing the mounting bolts (B) and nut (C).

7.
Remove the canister braket (B) installation bolt (A).

8.
Remove the fuel tank air filter & canister close valve assembly (A) after rotating it in the direction of the arrow in the figure.

9.
Release the lever (A), and then separate the canister close valve (B) from the fuel tank air filter (C) after rotating it in the direction of the arrow in the figure.

Fuel Filler Cap Description
A ratchet tightening device on the threaded fuel filler cap reduces the chances of incorrect installation, which would seal the fuel filler. After the gasket on the fuel filler cap and the fi ...

Fuel Tank Air Filter Installation
• Install the component with the specified torques. • Note that internal damage may occur when the component is dropped. In this case, u ...

See also:

Circuit Diagram
...

Input/Output Specification
Connector Pin Lay Out IMS input/output pin information No Signal Name I/O Contents Remark A1 - - - ...

Components Location
1. Engine Control Module (ECM) 2. Manifold Absolute Pressure Sensor (MAPS) 3. Intake Air Temperature Sensor (IATS) 4. Engine Coolant Temperature Sensor (ECTS) 5. Throttle Positi ...

Copyright www.ksmanual.com 2014-2026