Kia Sorento: Inspection
| [Evap Leak Test] |
Engine Control Module (ECM) controls Purge Control Solenoid Valve (PCSV)
and Canister Close Valve (CCV) for EVAP System diagnosis if the conditions are
satisfied.
ECM displays DTC codes after checking the leak rate through detecting
change of FTPS signal. (Refer to the DTC guide manual for DTC codes.)In addition,
EVAP Leak can be checked through the EVAP Leak Test function of the GDS diagnostic
tool as shown below.
| 1. |
Turn ignition switch OFF.
|
| 2. |
Connect the GDS to Data Link Connector (DLC).
|
| 3. |
Start the engine.
|
| 4. |
Select "Vehicle, Model year, Engine, System".
|
| 5. |
Select "Vehicle S/W Management".
|
| 6. |
Select "Inspection / Test".
|
| 7. |
Select "Evap Leak Test".
|
| 8. |
Perform the procedure in accordance with the message.
|
Components Location
1. Purge Control Solenoid Valve (PCSV)
2. Vapor line
3. Fuel tank air filter
4. Canister Close Valve (CCV)
5. Canister
6. Fuel Tank Pressure Sensor (FTPS)
...
Canister Removal
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Lift the vehicle.
3.
D ...
See also:
Front Wheel Transfer Assembly Components Location
1. Under cover
2. Transaxle Assembly
3. Transfer assembly
4. Propeller shaft
5. Coupling assembly
1. Under cover
2. Transaxle Assembly
3 ...
Engine And Transmission Assembly Removal
•
Use fender covers to avoid damaging painted surfaces.
•
...
Inspection
1.
Turn ignition switch OFF.
2.
Remove the air duct.
(Refer to Engine Mechanical System - "Air cleaner")
...
Categories
- Home
- First Generation
- Second Generation
- Kia Sorento XM 2011-2026 Owners Manual
- Kia Sorento XM 2011-2026 Service Manual
Copyright www.ksmanual.com 2014-2026