Kia Sorento: Starter Reassembly

Starter Disassembly

1. Disconnect the M-terminal (A) on the magnet switch assembly (B). 2. After loosening the screws (A), detach the magnet switch assembly ...

Starter Inspection

Starter Solenoid Inspection 1. Disconnect the lead wire from the M-terminal of solenoid switch. 2. Connect the battery as shown. If ...

See also:

Side Impact Sensor (SIS) Description
Side Impact Sensor (SIS) system consists of two Front-SIS which are installed at each center of the front door module (LH and RH) and two Rear-SIS which are installed at each rear pillar near ...

Outside thermometer
The current outside temperature is displayed in 1°F (1°C) increments. The temperature range is between - 40°F ~ 140°F (-40°C ~ 60°C). The outside temperature on the display may not change im ...

Inspection
1. Connect the GDS on the Data Link Connector (DLC). 2. Turn the ignition switch ON. 3. Measure the output volt ...