Kia Sorento: Battery Sensor Installation - Charging System - Engine Electrical System - Kia Sorento XM 2011-2024 Service ManualKia Sorento: Battery Sensor Installation

Second Generation XM (2011-2024) / Kia Sorento XM 2011-2024 Service Manual / Engine Electrical System / Charging System / Battery Sensor Installation

1.
Install in the reverse order of removal.

Battery sensor cable installation bolt:
10.8 ~ 13.7 N.m (1.1 ~ 1.4 kgf.m, 8.0 ~ 10.1 lb-ft)
Battery (-) terminal l tightening nut:
4.0 ~ 6.0 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)

  
•
For the vehicle equipped with a battery sensor, be careful not to damage the battery sensor when the battery is replaced or recharged.
1.
When replacing the battery, it should be same one (type, capacity and brand) that is originally installed on your vehicle. If a battery of a different type is replaced, the battery sensor may recognize the battery to be abnormal.
2.
When installing the ground cable on the negative post of battery, tighten the clamp with specified torque. An excessive tightening torque can damage the PCB internal circuit and the battery terminal .
3.
When recharging the battery, ground the negative terminal of the booster battery to the vehicle body.
Battery Sensor Removal
1. Disconnect the battery negative (-) cable. 2. Disconnect the battery sensor connector (A). 3. Remove the bat ...

Starting System
...

See also:

Starter Reassembly
1. Reassemble in the reverse order of disassembly. ...

Fender Replacement
   • When removing and installing the hood, an assistant is necessary. ...

Dynamic Damper Installation
1. Apply soap powder on the shaft to prevent being damaged between the shaft spline and the dynamic damper. 2. Install the dynamic damper. ...

Copyright © www.ksmanual.com 2014-2024