Kia Sorento: Water pump Inspection
Second Generation XM (2011-2025) / Kia Sorento XM 2011-2025 Service Manual / Engine Mechanical System / Cooling System / Water pump Inspection
| 1. |
Check each part for cracks, damage or wear, and replace the coolant
pump assembly if necessary.
|
| 2. |
Check the bearing for damage, abnormal noise and sluggish rotation,
and replace the coolant pump assembly if necessary.
|
| 3. |
Check for coolant leakage. If coolant leaks from hole, the seal is defective.
Replace the coolant pump assembly.
|
Water pump Removal and Installation
1.
Loosen the drain plug, and then drain the engine coolant.
Remove the radiator cap to help drain the coolant faster.
2.
Remove the dr ...
Water pump Troubleshooting
Symptoms
Possible Causes
Remedy
Coolant leakage
•
From the bleed hole of the water pump
Visually chec ...
See also:
Compressor Installation
1.
Make sure the compressor mounting bolt with the correct length
is screwed in. Tighten the mounting bolts with the specified tightening
order.
...
Checking the engine oil level
1. Be sure the vehicle is on level ground.
2. Start the engine and allow it to reach normal operating temperature.
3. Turn the engine off and wait for a few minutes (about 5 minutes) for the oil
...
Specifications
Direct control VFS[T/CON]
▷ Control type : Normal low type
Control Pressure kpa
(kgf/cm², psi)
0 ~ 539.37 (0 ~ 5.5, 0 ~ 78.23)
Current value(mA)
...
Categories
- Home
- First Generation
- Second Generation
- Kia Sorento XM 2011-2025 Owners Manual
- Kia Sorento XM 2011-2025 Service Manual
Copyright www.ksmanual.com 2014-2025