Kia Sorento: Flat tire

The jack, jack handle, wheel lug nut wrench are stored in the luggage compartment.
Pull up the luggage box cover to reach this equipment.
(1) Jack handle
(2) Jack
(3) Wheel lug nut wrench
(4) Socket
Jacking instructions
The jack is provided for emergency tire changing only.
To prevent the jack from “rattling” while the vehicle is in motion, store it properly.
Follow jacking instructions to reduce the possibility of personal injury.
WARNING - Changing tires
Removing and storing the spare tire

Your spare tire is stored underneath your vehicle, directly below the cargo area.
To remove the spare tire:
1.Open the tailgate.
2.Find the hex bolt cover and bend the cover back.

3.Connect the socket and wheel lug nut wrench.
4.Use the wheel lug nut wrench to loosen the bolt enough to lower the spare tire.
Turn the wrench counterclockwise until the spare tire reaches the ground.

5.After the spare tire reaches the ground, continue to turn the wrench counterclockwise, and draw the spare tire outside. Never rotate the wrench excessively, otherwise the spare tire carrier may be damaged.
6.Remove the retainer (1) from the center of the spare tire.

To store the spare tire:
1.Lay the tire on the ground with the valve stem facing up.
2.Place the wheel under the vehicle and install the retainer (1) through the wheel center.
3.Turn the wrench clockwise until it clicks.
WARNING
Ensure the spare tire retainer is properly aligned with the center of the spare tire to prevent the spare tire from “rattling”. Otherwise, it may cause the spare tire to fall off the carrier and lead to an accident.
Changing a tire with TPMS
Changing tiresMaster Cylinder Installation
1.
Installation is the reverse of removal.
2.
After installation, bleed the brake system.
(Refer to Brake system - "Brake system B ...
Occupant Detection system (ODS) Description
In order to make normal activation of airbag system, SRSCM detects DTC(s)
for the Passenger side Body Detection System. If the seat is occupied, Body
sensor detects how measuring electrostati ...
Auto Head lamp leveling Unit Operation
Operating Procedure
1.
Suspension angle change resulted from vehicle's load change.
2.
Height sensor signal change
...