Kia Sorento: Rear Blower Resister Inspection
Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Heating,Ventilation And Air Conditioning / Rear Air Conditioner / Rear Blower Resister Inspection
| 1. |
Measure terminal-to-terminal resistance of the blower resistor.
|
| 2. |
If the measured resistance is not within specification, the blower
resistor must be replaced. (After removing the resistor)
|
Rear Blower Unit Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Recover the refrigerant with a recover/recycling/charging station.
3.
...
Rear Blower Resister Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the rear luggage side trim.
(Refer to Body - "Interior Trim")
...
See also:
Blower Motor Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the passenger side crash pad under cover (A).
3.
...
Input/Output Specification
Connector Pin Lay Out
IMS input/output pin information
No
Signal Name
I/O
Contents
Remark
A1
-
-
-
...
Interior B
* These dimensions indicated in this figure are actual-measurement
dimensions. [ Unit : mm (inch) ]
...
Categories
- Home
- First Generation
- Second Generation
- Kia Sorento XM 2011-2026 Owners Manual
- Kia Sorento XM 2011-2026 Service Manual
Copyright www.ksmanual.com 2014-2026