Kia Sorento: Blower Resistor Replacement

Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Heating,Ventilation And Air Conditioning / Blower / Blower Resistor Replacement

1.	Disconnect the negative (-) battery terminal.

2.	Remove the passenger side crash pad under cover (A).

3.	Disconnect the connector and then remove the blower resistor (A) after loosening the mounting screws.

4.	Install in the reverse order of removal.

Blower Resistor Inspection

1. Measure the resistance between the terminals. 2. The measured resistance is not within specification, the blower resistor must be replac ...

Power Mosfet (DATC) Inspection

1. Measure the resistance between the terminals. 2. If the measured resistance is not within specification, the blower resistor must be rep ...

See also:

Passenger Airbag (PAB) Module Description
Passenger Airbag (PAB) module is located in the passenger crash pad. This PAB contains 2 firing squibs of airbag and 1 firing squib of active vent. Depending of crash speed or the tightening ...

Schematic Diagram
Canister Canister is filled with charcoal and absorbs evaporated vapor in fuel tank. The gathered fuel vapor in canister is drawn into the intake manifold by the ECM/PCM when appropri ...

Emergency Fastening Device (EFD) Removal
1. Disconnect the battery negative cable, and wait for at least thirty seconds before beginning work. 2. Remove the EFD cover pad (A). ...

Categories

Copyright © www.ksmanual.com 2014-2026