Kia Sorento: Mode Control Actuator Description

The mode control actuator is located at the heater unit.

It adjusts the position of the mode door by operating the mode control actuator based on the signal of the A/C control unit. Pressing the mode select switch makes the mode control actuator shift in order of Vent → Bi-Level → Floor → Mix.

Temperature Control Actuator Replacement

[Driver's side] 1. Disconnect the negative (-) battery terminal. 2. Using a screwdriver or remover, remove the driver's si ...

Mode Control Actuator Inspection

1. Turn the ignition switch OFF. 2. Disconnect the mode control actuator connector. 3. Verify that the mode con ...

See also:

Heated Steering wheel System Circuit Diagram
Terminal Function Housing Pin Function Wire color Pad A GND Back B HEATER Yellow C ...

Output Speed Sensor Inspection
1. Check signal waveform of Input & output speed sensor using the GDS. Specification : Refer to "Signal Wave Form" section. ...

Ignition Coil Removal
1. Disconnect the battery nagative terminal. 2. Remove the engine cover. 3. Disconnect the ignition coil connec ...