Kia Sorento: Photo Sensor Inspection - Air conditioning System - Heating,Ventilation And Air Conditioning - Kia Sorento XM 2011-2026 Service ManualKia Sorento: Photo Sensor Inspection

Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Heating,Ventilation And Air Conditioning / Air conditioning System / Photo Sensor Inspection

1.
Turn the ignition switch ON.
2.
Connect the GDS.
3.
Emit intensive light toward the photo sensor using a lamp, and check the output voltage change.
4.
The voltage will rise with higher intensive light and reduce with lower intensive light.

1. Sensor REF (+5V)
2. -
3. Right Photo (-)
4. -
5. Left Photo (-)
6. -
7. -
8. -

Photo Sensor Description
The photo sensor is located at the center of the defrost nozzles. The photo sensor contains a photovoltaic (sensitive to sunlight) diode. The solar radiation received by its light receiving ...

Photo Sensor Replacement
1. Disconnect the negative (-) battery terminal. 2. With a flat-head screwdriver, remove the photo sensor (A) from the center of the defros ...

See also:

Side Body B
* These dimensions indicated in this figure are actual-measurement dimensions. [ Unit : mm (inch) ] ...

Using the USB device
To use an external USB device, make sure the device is not connected when starting up the vehicle. Connect the device after starting up. If you start the engine when the USB device is connected ...

Driver Airbag (DAB) Module and Clock Spring Components
1. Driver Airbag (DAB) 2. Steering Wheel 3. Clock Spring ...

Copyright www.ksmanual.com 2014-2026