Kia Sorento: A/C Pressure Transducer Replacement - Air conditioning System - Heating,Ventilation And Air Conditioning - Kia Sorento XM 2011-2026 Service ManualKia Sorento: A/C Pressure Transducer Replacement

Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Heating,Ventilation And Air Conditioning / Air conditioning System / A/C Pressure Transducer Replacement

1.
Disconnect the negative (-) battery terminal.
2.
Recover the refrigerant with a recovery/charging station.
3.
Disconnect the A/C pressure transducer connector (A).

4.
Remove the A/C pressure transducer (A).

Tightening torque :
10 ~ 12 N.m (1.0 ~ 1.2 kgf.m, 7.4 ~ 8.8 lb-ft)

  
Be careful not to bend the liquid & suction pipe.
5.
Install in the reverse order of removal.

  
When installing, replace it with a new O-ring (A).
A/C Pressure Transducer Inspection
1. Measure the pressure of high pressure line by measuring voltage output between terminal “1” and “2”. 2. Inspect the volt ...

Evaporator Temperature Sensor Description
The evaporator temperature sensor will detect the evaporator core temperature and interrupt compressor relay power in order to prevent evaporator from freezing by excessive cooling ...

See also:

Rear Bumper Components
1. Rear bumper cover 2. Rear bumper lower bracket [RH] 3. Rear bumper lower bracket [LH] 4. Rear bumper side bracket [RH] 5. Rear bumper side bracket [LH] ...

TPMS Receiver Operation
1. General Function A. Auto learn takes place only once per Ignition cycle. B. On successful compl ...

Fuel Pressure Control Valve
Fuel Pressure Control Valve is installed on the high pressure fuel pump and controls fuel flow flowing into the injectors in accordance with the ECM signal calculated based on various engine ...

Copyright www.ksmanual.com 2014-2026