Kia Sorento: Blind Spot Detection Unit Removal

Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Body Electrical System / Blind Spot Detection System / Blind Spot Detection Unit Removal

1.	Disconnect the negative (-) battery terminal.

2.	Remove the rear bumper. (Refer to Body - "Rear Bumper")

3.

Remove the BSD unit (A) after loosening the mounting screws.

Take care not to separate the bracket from rear bumper when removing the BSD sensor.

Blind Spot Detection Unit Circuit Diagram

...

Blind Spot Detection Unit Installation

1. Install the BSD units to the rear bumper. 2. Install the rear bumper. 3. Connect the negative (-) battery te ...

See also:

Inspection
1. Turn the ignition switch OFF. 2. Disconnect the CCV connector. 3. Measure resistance between the CCV termina ...

Compressor Components
1. Center Bolt 2. Hub Bolt 3. Hub Assembly 4. Snap Ring 5. Pulley 6. Compressor Assembly 7. Electric Control Valve ...

Cruise control system
1. Cruise indicator 2. Cruise set indicator The cruise control system allows you to program the vehicle to maintain a constant speed without pressing the accelerator pedal. This system is design ...

Categories

Copyright © www.ksmanual.com 2014-2026