Kia Sorento: Inspection - Ignition Switch Assembly - Body Electrical System - Kia Sorento XM 2011-2025 Service ManualKia Sorento: Inspection

Second Generation XM (2011-2025) / Kia Sorento XM 2011-2025 Service Manual / Body Electrical System / Ignition Switch Assembly / Inspection

1.
Disconnect the ignition switch connector (B) and key warning switch connector (A) from under the steering column.

2.
Check for continuity between the terminals.
3.
If continuity is not specified, replace the switch.

Ignition Switch Assembly
...

Removal
1. Disconnect the negative (-) battery terminal. 2. Remove the steering column upper and lower shrouds. (Refer to Steering System - &quo ...

See also:

Front Fog Lamps Inspection
1. With the fog lamp switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the multifunctio ...

Seat Heater Switch Inspection
Front Seat Heater Switch 1. Disconnect the negative (-) battery terminal. 2. Remove the center fascia panel (A). (Refer to Body - &q ...

Brake Booster Brake Booster Operating Test
For simple checking of the brake booster operation, carry out the following tests. 1. Run the engine for one or two minutes, and then stop it. If the pedal depresses ...

Copyright www.ksmanual.com 2014-2025