Kia Sorento: Rear combination lamp Removal

Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Body Electrical System / Lighting System / Rear combination lamp Removal

1.	Disconnect the negative (-) battery terminal. [Outside]

2.	Loose the screws (2EA) holding the rear combination lamp then disconnect the connector (A) then remove the outside rear combination lamp (B).

3.	Replace the bulbs (B) after removing the rear combination lamp assembly (A). [Inside]

4.	If the bulbs should be only replaced without removing lamp assembly, replace the bulbs after removing the rear combination lamp cover inside trunk.

5.	Remove the tail gate service covers (A) when removing the inside rear combination lamp assembly.

6.	Disconnect the lamp cover on tailgate. Remove the lamp assembly (A) after loosening nuts (3EA) and disconnecting the connector.

7.	Remove the tailgate combination lamp assembly (A) and then replace the bulbs (B).

8.	If the bulbs should be only replaced without removing lamp assembly, replace the bulbs after removing the tailgate lamp cover inside trunk.

Cargo Lamp Installation

1. Replace the lamp bulb. 2. Install the cargo lamp assembly after connecting the lamp connector. ...

Rear combination lamp Installation

1. Install the tailgate combination lamp assembly after replacing the bulb. 2. Install the lamp cover to the tailgate after connecting the ...

See also:

Fuel Tank Pressure Sensor (FTPS)
Fuel Tank Pressure Sensor (FTPS) is a component of the evaporative emission control system and is installed on the fuel tank, the fuel pump, or the canister. It checks the purge control solen ...

Alternator Description
The Alternator has eight built-in diodes, each rectifying AC current to DC current. Therefore, DC current appears at alternator "B" terminal. In addition, the charging voltage ...

Categories

Copyright © www.ksmanual.com 2014-2026