If there are any regulations pertinent to the aiming of head lamps
in the area where the vehicle is to be used, adjust so as to meet those
requirements.
|
1. |
Inflate the tires to the specified pressure and remove any loads
from the vehicle except the driver, spare tire, and tools.
|
2. |
The vehicle should be placed on a flat floor.
|
3. |
Draw vertical lines (Vertical lines passing through respective
head lamp centers) and a horizontal line (Horizontal line passing through
center of head lamps) on the screen.
|
4. |
With the head lamp and battery in normal condition, aim the head
lamps so the brightest portion falls on the vertical lines.
A : High - Vertical
B : Low - Horizontal
C : Low - Vertical
[General type]
[HID type]
|
|
1. |
Turn the low beam on with driver seated in the vehicle.
The cut-off line should be projected in the allowable range shown
in the picture.
In case of equipping with the manual leveling device, set the
leveling device switch on the "O" position.
In case of equipping with the auto leveling device, set the initialization
by using the diagnostic tool before aiming.
|
2. |
Turn the front fog lamp on with driver seated in the vehicle.
The cut-off line should be projected in the allowable range shown
in the picture.
|
Hood Adjustment
Adjust Hood
1.
After loosening the hinge (A) mounting bolt, adjust the hood (B)
by moving it up or down, or right or left.
2.
Adjust th ...
Circuit Diagram
...
Fuel Filler Cap Description
A ratchet tightening device on the threaded fuel filler cap reduces the
chances of incorrect installation, which would seal the fuel filler. After the
gasket on the fuel filler cap and the fi ...