Kia Sorento: Windshield Wiper-Washer Switch Inspection
Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Body Electrical System / Windshield Wiper/Washer / Windshield Wiper-Washer Switch Inspection
Check for continuity between the terminals while operating the wiper and
washer switch. If it is not normal condition, replace wiper and wiper switch.
Wiper Switch
Washer Switch
Rear Wiper Switch
Rear Washer Switch
Head Lamp Washer Switch
| 1. |
Disconnect the negative(-) battery terminal.
|
| 2. |
Remove the crash pad lower panel (A).
(Refer to Body - "Crash pad")
|
| 3. |
Remove the side garnish (A) after loosening the screws.
|
| 4. |
Remove the head lamp washer switch (A).
|
| 5. |
Make sure that the continuity exists between the terminals as
below. If it is not normal condition, replace the head lamp washer switch
|
Windshield Wiper-Washer Switch Installation
1.
Install the windshield wiper switch.
2.
Connect the wiper switch connector.
3.
Install the steering column u ...
Front Wiper Motor Component Location
1. Cap
2. Nut
3. Wiper arm & blade
4. Retainer
5. Cowl top cover
6. Bolt
7. Wiper motor & linkage assembly
8. Wiper motor connector
...
See also:
Line Pressure Control Solenoid Valve
line pressure control solenoid valve is attached to the valve body. This
variable force solenoid valve directly controls the hydraulic pressure inside
the line pressure.
...
IMS Power Seat Control Installation
1.
Install the power seat control switch after connecting the connector.
...
TJ Joint Components
[LH]
1. BJ assembly
2. BJ circlip
3. BJ boot band
4. BJ boot
5. Shaft
6. TJ boot band
7. TJ boot
8. Spider assembly
9. Retainer ring
10. ...
Categories
- Home
- First Generation
- Second Generation
- Kia Sorento XM 2011-2026 Owners Manual
- Kia Sorento XM 2011-2026 Service Manual
Copyright www.ksmanual.com 2014-2026