1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the center fascia panel (A).
(Refer to Body - "Crash pad")
|
3. |
Disconnect the connectors and cables (A) from center fascia panel.
|
4. |
Remove the heater control unit (A) with the rear glass defogger
switch.
|
Pressure Sensor Description
The 4WD ECU makes a Motor Pump(Actuator) turn round for generating an
oil pressure. And then it presses a multiple disk clutch and transfers the generated
torque into rear wheels. Its torque ...
Filter replacement
It must be replaced when necessary, and should not be washed.
You can clean the filter when inspecting the air cleaner element. Clean the filter
by using compressed air.
1. Loosen the air clean ...
Tire replacement
If the tire is worn evenly, a tread wear indicator will appear as a solid band
across the tread. This shows there is less than 1/16 inch (1.6 mm) of tread left
on the tire. Replace the tire when t ...