Kia Sorento: Power Window Switch Inspection
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the front door trim and power window switch.
(Refer to Body - "Front door")
|
| 3. |
Check for continuity between the terminals in each switch position
according to the table. If the continuity condition is not normal, replace
the switch.
|
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the front door trim and power window switch.
(Refer to Body - "Front door")
|
| 3. |
Check for continuity between the terminals in each switch position
according to the table. If the continuity condition is not normal, replace
the switch.
|
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the rear door trim.
(Refer to Body - "Rear door")
|
| 3. |
Remove the rear power window switch module (A).
|
| 4. |
Check for continuity between the terminals in each switch position
according to the table. If the continuity condition is not normal, replace
the switch.
[IMS]
[General]
|
Power Window Switch Components
TroubleshootingRear Glass Defogger Switch Installation
1.
Install the heater control unit.
2.
Install the center fascia panel.
...
In-car Sensor Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Using a screwdriver or remover, remove the center fascia panel
(A).
...
Parking Brake Pedal Assembly Removal
1.
Turn ignition switch OFF and disconnect the negative (-) battery
cable.
2.
Remove the crash pad lower panel.
(Refer to Body - & ...