Kia Sorento: Power Door Mirror Actuator Inspection
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the driver door module.
(Refer to Body - "Front door")
|
| 3. |
Disconnect the connector from the mirror.
|
| 4. |
Verify that the mirror operates properly as shown in the table.
Mirror Heater
Turn Signal Lamp
BSD Warning Lamp
Mirror Folding
|
Power Door Mirror Switch Inspection
Power WindowsTroubleshooting, Customer Complaint Analysis Check Sheet
There are six areas where a problem can occur: wiring harness, the radio,
the CD player, and speaker. Troubleshooting enables you to confine the problem
to a particular area.
Chart 1 ...
Cylinder Head Inspection
Cylinder Head
1.
Inspect for flatness.
Using a precision straight edge and feeler gauge, measure the surface
the contacting the cylinder block and the manifolds fo ...
Compass Mirror Calibration Procedure
If the compass has been calibrated or set to variance zone number incorrectly,
or you are driving in specific places (tunnel, parking lot in building, underground
parking lot, near transforme ...