Kia Sorento: Power Door Lock Actuators Inspection - Power Door Locks - Body Electrical System - Kia Sorento XM 2011-2026 Service ManualKia Sorento: Power Door Lock Actuators Inspection

Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Body Electrical System / Power Door Locks / Power Door Lock Actuators Inspection

Front Door Lock Actuator
1.
Remove the front door trim.
(Refer to Body - "Front door")
2.
Remove the front door module.
(Refer to Body - "Front door")
3.
Disconnect the connectors from the actuator.

4.
Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.

Rear Door Lock Actuator
1.
Remove the rear door trim.
(Refer to Body - "Rear door")
2.
Remove the rear door module.
(Refer to Body - "Rear door")
3.
Disconnect the connectors from the actuator.

4.
Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.

Tailgate Lock Actuator Inspection
1.
Remove the tailgate trim.
(Refer to Body - "Tailgate")
2.
Disconnect the 4P connector from the actuator.

3.
Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.

Front Door Lock Switch
1.
Remove the front door trim.
(Refer to Body - "Front door")
2.
Remove the front door module.
(Refer to Body - "Front door")
3.
Disconnect the connectors from the actuator.

4.
Check for continuity between the terminals in each switch position when inserting the key into the door according to the table.

Rear Door Lock Switch
1.
Remove the rear door trim.
(Refer to Body - "Rear door")
2.
Remove the rear door module.
(Refer to Body - "Rear door")
3.
Disconnect the connectors from the actuator.

4.
Check for continuity between the terminals in each switch position according to the table.

Tailgate Switch
1.
Remove the tailgate trim.
(Refer to Body - "Tailgate")
2.
Disconnect the 4P connector from the actuator.

3.
Check for continuity between the terminals in each switch position according to the table.

Component Location
1. Driver power window main switch 2. Passenger window switch 3. IPM (Intalligent intergrated Platform Module) 4. Door lock switch 5. Tailgate lock actuator & switch ...

Power Door Lock Switch Removal
Driver Power Window Main Switch 1. Disconnect the negative battery terminal. 2. Remove the front door trim. (Refer to Body - "F ...

See also:

Side Airbag (SAB) Module Installation
   Be sure to install the harness wires not to be pinched or interfered with other parts. ...

Rear Differential Carrier Component
1. Rear Differential Carrier 2. Coupling Assembly ...

Vehicle load limit
Tire and loading information label The label located on the driver's door sill gives the original tire size, cold tire pressures recommended  for your vehicle, the number of people tha ...

Copyright www.ksmanual.com 2014-2026