Kia Optima Manuals

Kia Sorento: Troubleshooting - Indicators And Gauges - Body Electrical System - Kia Sorento XM 2011-2026 Service ManualKia Sorento: Troubleshooting

Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Body Electrical System / Indicators And Gauges / Troubleshooting

Symptom
 Possible cause
 Remedy
Speedometer does not operate
 Cluster fuse (10A) blown
 Check for short and replace fuse
Speedometer faulty
 Check speedometer
CAN line faulty
 Check the EMS
Wiring or ground faulty
 Repair if necessary
Tachometer does not operate
 Cluster fuse (10A) blown
 Check for short and replace fuse
Tachometer faulty
 Check tachometer
CAN line faulty
 Check the EMS
Wiring or ground faulty
 Repair if necessary
Fuel gauge does not operate
 Cluster fuse (10A) blown
 Check for short and replace fuse
Fuel gauge faulty
 Check gauge
Fuel sender faulty
 Check fuel sender
Wiring or ground faulty
 Repair if necessary
Low fuel warning lamp does not light up
 Cluster fuse (10A) blown
 Check for short and replace fuse
Fuel sender faulty
 Check fuel sender
Wiring or ground faulty
 Repair if necessary
Water temperature gauge does not
operate
 Cluster fuse (10A) blown
 Check for short and replace fuse
Water temperature gauge faulty
 Check gauge
Water temperature sender faulty
 Check sender
CAN line faulty
 Check the EMS
Wiring or ground faulty
 Repair if necessary
Oil pressure warning lamp does not
light up
 Cluster fuse (10A) blown
 Check for short and replace fuse
Oil pressure switch faulty
 Check switch
Wiring or ground faulty
 Repair if necessary
Parking brake warning lamp does not
light up
 Cluster fuse (10A) blown
 Check for short and replace fuse
Brake fluid level warning switch faulty
 Check switch
Parking brake switch faulty
 Check switch
Wiring or ground faulty
 Repair if necessary
Open door warning lamp and tailgate
warning lamp do not light up
 Memory fuse (15A) blown
 Check for short and replace fuse
Door switch faulty
 Check switch
Wiring or ground faulty
 Repair if necessary
Seat belt warning lamp does not light up
 Cluster fuse (10A) blown
 Check for short and replace fuse
Seat belt switch faulty
 Check switch
Wiring or ground faulty
 Repair if necessary
Speedometer and odometer does not
operate
 CAN line faulty
 Check the ABS ECU
Wheel speed sensor faulty
 Check the wheel speed sensor

Instrument Cluster Inspection
1. Check the suspected area as below table when the warning light is error. NO Warning light Description Communicatio ...

Power Door Locks
...

See also:

Side Impact Sensor (SIS) Description
Side Impact Sensor (SIS) system consists of two Front-SIS which are installed at each center of the front door module (LH and RH) and two Rear-SIS which are installed at each rear pillar near ...

Start/Stop Button Component
...

Operation
Power Tailgate Opening ** - Primary switch signal received by PTGM via CAN bus (sent by IPM) PTGM Opening procedure: 1. Opening can be triggered after a signal i ...

Categories

Copyright www.ksmanual.com 2014-2026