Kia Sorento: IPM Installation - BCM (Body Control Module) - Body Electrical System - Kia Sorento XM 2011-2024 Service ManualKia Sorento: IPM Installation

Second Generation XM (2011-2024) / Kia Sorento XM 2011-2024 Service Manual / Body Electrical System / BCM (Body Control Module) / IPM Installation

1.
Install IPM(Intelligent intergrated Platform Module).
2.
Connect the IPM connector.
3.
Install the crash pad lower panel.
IPM Removal
1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel (A). (Refer to Body - "Crash pad") ...

IPM Trouble Diagnostics When Using GDS
1. The IPM can be diagnosed by using the GDS. The BCM communicates with the GDS which then displays inputs and outputs along with codes. 2. ...

See also:

Tire replacement
If the tire is worn evenly, a tread wear indicator will appear as a solid band across the tread. This shows there is less than 1/16 inch (1.6 mm) of tread left on the tire. Replace the tire when t ...

Starter Disassembly
1. Disconnect the M-terminal (A) on the magnet switch assembly (B). 2. After loosening the screws (A), detach the magnet switch assembly ...

Component Location
1. Slide motor 2. Front height motor 3. Rear height motor 4. Lumber support motor 5. Power seat switch 6. Reclining motor 7. Reclining switch 8. Lumber support swit ...

Copyright В© www.ksmanual.com 2014-2024