1. |
Check IPM input/output specification of multifunction switch using
the GDS. If the specification is abnormal, replace the lamp or wiper
switch.
|
2. |
If diagnosis is required on the multifunction switch, select model
and "IPM".
|
3. |
Select "Current data" and check the input/output condition of
"Multifunction switch".
|
4. |
To perform test on "Multifunction switch" outputs, select "Actuation
test".
|
TJ Joint Installation
1.
Wrap tape around the driveshaft spline(TJ) to prevent damage to
the boot.
2.
Using the alignment marks (D) made during disassembly as a ...
Positive Crankcase Ventilation (PCV) Valve Installation
1.
Install in the reverse order of removal.
PCV Valve installation:
1.9 ~ 2.8 N.m (0.19 ~ 0.29 kgf.m, 1.4 ~ 2.1 lb-ft)
...
Inspection
1.
Turn ignition switch OFF.
2.
Remove the air duct.
(Refer to Engine Mechanical System - "Air cleaner")
...