Kia Sorento: Installation

Removal

1. Disconnect the negative (-) battery terminal. 2. Remove the steering column upper and lower shrouds (A) after removing 3 screws. ...

Inspection

Lighting Switch Inspection 1. With the multi function switch in each position, make sure that continuity exists between the terminals below. If continuity is no ...

See also:

Certification label
The certification label is located on the driver's door sill at the center pillar. This label shows the maximum allowable weight of the fully loaded vehicle. This is called the GVWR (Gross Veh ...

Circuit Diagram
...

Transaxle Oil Temperature Sensor Inspection
1. Turn ignition switch OFF. 2. Remove the air duct. (Refer to Engine Mechanical System - "Air cleaner") ...