Kia Sorento: Removal

Second Generation XM (2011-2025) / Kia Sorento XM 2011-2025 Service Manual / Body Electrical System / Multifunction switch / Removal

1.	Disconnect the negative (-) battery terminal.

2.	Remove the steering column upper and lower shrouds (A) after removing 3 screws.

3.	Disconnect the light switch connector (A) and the wiper switch connector (B).

4.

Remove the wiper switch (A) by pushing the lock pin (B).

When removing the wiper & washer switch only, release the lock of wiper switch without removing the steering wheel.

5.	Remove the steering wheel. (Refer to Steering System - "Steering column and shaft")

6.	Remove the clock spring. (Refer to Restraint - "Airbag module")

7.	Loosen the screws from the multifunction switch assembly (A).

Component

...

Installation

1. Install the multifunction switch. 2. Install the clock spring and steering wheel. 3. Install the steering co ...

See also:

Blind spot detection system (BSD) (If equipped)
The BSD (Blind spot detection) system uses a radar sensor to alert the driver while driving. It senses the rear side territory of the vehicle and provides information to the driver. ➀ BSD ...

Hazard warning flasher
The hazard warning flasher serves as a warning to other drivers to exercise extreme caution when approaching, overtaking, or passing your vehicle. It should be used whenever emergency repairs are ...

Electronic stability control (ESC)
The Electronic Stability control (ESC) system is designed to stabilize the vehicle during cornering maneuvers. ESC checks where you are steering and where the vehicle is actually going. ESC applie ...

Categories

Copyright © www.ksmanual.com 2014-2025