Kia Sorento: Quarter Fixed Glass Installation
1. |
With a putt knife, scrape the old adhesive smooth to a thickness
of about 2mm (0.08 in.) on the bonding surface around the entire quarter
fixed glass flange.
A. |
Do not scrape down to the painted surface of the body;
damaged paint will interfere with proper bonding.
|
B. |
Mask off surrounding surfaces before painting.
|
C. |
Remove the fasteners from the body.
|
|
2. |
Clean the body bonding surface with a sponge dampened in alcohol.
After cleaning, keep oil, grease and water from getting on the surface.
|
3. |
With a sponge, apply a light coat of glass primer along the edge
of the quarter fixed glass as shown, then lightly wipe it off with gauze
or cheese cloth :
A. |
Do not apply body primer to the quarter fixed glass, and
do not get body and glass primer sponges mixed up.
|
B. |
Never touch the primed surfaces with your hands. If you
do, the adhesive may not bond to the quarter fixed glass properly,
causing a leak after the quarter fixed glass in installed.
|
C. |
Keep water, dust, and abrasive materials away from the
primed surface.
|
|
4. |
With a sponge, apply a light coat of body primer to the original
adhesive remaining around the flange. Let the body primer dry for at
least 10 minutes.
A. |
Do not apply glass primer to the body, and be careful
not to mix up glass and body primer sponges.
|
B. |
Never touch the primed surfaces with your hands.
|
|
5. |
Remove the tape sticked to the quater fixed glass.
|
6. |
Install the quater fixed glass mounting nuts.
|
7. |
Install the quarter fixed glass (A).
Tightening torque :
5.9 ~6.4N.m (0.6~0.65Kgf.m, 4.3~4.7lb-ft)
|
|
8. |
Let the adhesive dry for at least one hour, then spray water over
the rear window and check for leaks. Mark the leaking areas, let the
rear window dry, then seal with sealant. Let the vehicle stand for at
least four hours after rear window installation. If the vehicle has
to be used within the first four hours, it must be driven slowly.
|
9. |
Reinstall all remaining removed parts.
|
10. |
Install the following items.
F. |
Third row seat assembly
|
G. |
Second row seat assembly
|
|
•
Put on gloves to protect your hands.
•
...
See also:
Components Location
1. Front axle
2. Front lower arm
3. Drive shaft
4. Sub frame
5. Stabilizer bar
6. Steering gearbox
7. Stabilizer link
8. Front strut assembly
...
Multimedia Jack Description
The multimedia jack on the console upper cover is for customers who like
to listen to external portable music players like the MP3, iPod and etc., through
the vehicle's sound system when ...
Engine compartment
1. Engine coolant reservoir
2. Engine oil filler cap
3. Brake fluid reservoir
4. Air cleaner
5. Fuse box
6. Positive battery terminal
7. Negative battery terminal
8. Windshield washer fluid r ...