Kia Optima Manuals

Kia Sorento: Mirror Replacement - Exterior - Body (Interior and Exterior) - Kia Sorento XM 2011-2025 Service ManualKia Sorento: Mirror Replacement

Second Generation XM (2011-2025) / Kia Sorento XM 2011-2025 Service Manual / Body (Interior and Exterior) / Exterior / Mirror Replacement

Outside Rear View Mirror Assembly Replacement
  
•
When prying with a flat-up screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Put on gloves to protect your hands.
1.
Using a screwdriver, remove the quadrant inner cover (A).
2.
Push the lock pin (B), then remove the tweeter speaker connector (C).
3.
After disconnecting the connector (A), then remove the outside rear view mirror (B).
Tightening torque :
6.9~10.8 N.m (0.7~1.1 kgf.m, 5.1~8.0 lb-ft)

4.
Install in the reverse order of removal.
Inside Rear View Mirror Assembly Replacement
[Manual Mirror]
1.
Push the inside rear view mirror base (A) up to remove the inside rear view mirror assembly (C).
2.
Install in the reverse order of removal.
[ECM Mirror]
1.
Remove the ECM mirror cover (A).
2.
Disconnect the ECM mirror connector (B).
3.
Loosen the ECM mirror mounting screw.
4.
Push the ECM mirror base up to remove the ECM mirror assembly (A).
5.
Install in the reverse order of removal.
  
•
Make sure the connector is connected properly.
Panorama Sunroof Adjustment
Inspect Glass Alignment 1. Inspect the alignment of the movable glass (C) that is between the front (A) and rear (B) glass and if needed adjust it. ...

Cowl Top Cover Replacement
1. Remove the cap (A) and remove the nuts, then remove the wiper arm (B). Tightening torque : 22.6 ~ 26.5 N.m(2.3 ~ 2.7 kgf.m, 16.6 ~ ...

See also:

User Settings Mode
Description On this mode, you can change setting of the doors, lamps, and so on. Door Auto Door Lock (if equipped) • Off: The auto door lock operation will be deactivated. • Speed: ...

Timing Chain Installation
1. Install the balance shaft chain. (Refer to Lubrication system - "Balance Shaft & Oil Pump") 2. Install the crankshaft ...

Starter Description
The starting system includes the battery, starter, solenoid switch, ignition switch, inhibitor switch (A/T), clutch pedal switch (M/T), ignition lock switch, connection wires and the battery ...

Categories

Copyright www.ksmanual.com 2014-2025