Wiper Switch
Washer Switch
Rear Wiper Switch
Rear Washer Switch
1. |
Disconnect the negative(-) battery terminal.
|
2. |
Remove the crash pad lower panel (A).
(Refer to Body - "Crash pad")
|
3. |
Remove the side garnish (A) after loosening the screws.
|
4. |
Remove the head lamp washer switch (A).
|
5. |
Make sure that the continuity exists between the terminals as
below. If it is not normal condition, replace the head lamp washer switch
|
Rear Washer Motor Inspection
1.
With the washer motor connected to the reservoir tank, fill the
reservoir tank with water.
...
Ambient Temperature Sensor Description
The ambient temperature sensor is located at the front of the condenser
and detects ambient air temperature. It is a negative type thermistor; resistance
will increase with lower temperature, ...
Transmitter Code Registration (Using GDS)
1.
Connect the DLC cable of GDS to the data link connector (16 pins)
in driver side crash pad lower panel, turn the power on GDS.
2.
...