Kia Sorento: Water Temperature Control Assembly Removal
Second Generation XM (2011-2024) / Kia Sorento XM 2011-2024 Service Manual / Engine Mechanical System / Cooling System / Water Temperature Control Assembly Removal
| 1. |
Disconnect the battery negative terminal.
|
| 2. |
Loosen the drain plug and drain the engine coolant.
|
| 3. |
Remove the radiator upper hose and lower hose.
(Refer to Cooling System - "Radiator")
|
| 4. |
Disconnect the connectors and then remove the wiring protector (A).
|
| 5. |
Disconnect the E.T.C cooler hose (A) and the remove the water temperature
control assembly(A).
|
| 6. |
Install in the reverse order of removal.
|
Water Temperature Control Assembly Components
1. O-ring
2. Water temperature control assembly
3. Water inlet fitting
4. Engine coolant temperature sensor
5. Thermostat
6. Thermostat gasket
7. Oil cooler coolant ho ...
Thermostat Removal and Installation
Removal of the thermostat would have an adverse effect, causing a lowering
of cooling efficiency. Do not remove the ther ...
See also:
High Mounted stop lamp Removal
High Mounted Stop Lamp
1.
Disconnect the negative (-) battery terminal.
2.
Remove the tailgate trim.
(Refer to Body - " ...
Components
...
Description
Manifold Absolute Pressure Sensor (MAPS) is a speed-density type sensor
and is installed on the surge tank. It senses absolute pressure of the surge
tank and transfers the analog signal propo ...
Copyright В© www.ksmanual.com 2014-2024