Kia Sorento: Troubleshooting
| Problem Symptoms Table |
| Symptom |
Suspect Area |
Reference |
| Lower pedal or spongy pedal |
1. Brake system (Fluid leaks) 2. Brake system (Air in) 3. Piston seals (Worn or damaged) 4. Rear brake shoe clearance(Out of adjustment) 5. Master cylinder (Inoperative) |
repair air·bleed replace adjust replace |
| Brake drag |
1. Brake pedal free play (Minimum) 2. Parking brake lever travel (Out of adjustment) 3. Parking brake wire (Sticking) 4. Rear brake shoe clearance(Out of adjustment) 5. Pad or lining (Cracked or distorted) 6. Piston (Stuck) 7. Piston (Frozen) 8. Anchor or shoe (Inoperative) 9. Booster system (Vacuum leaks) 10. Master cylinder (Inoperative) |
adjust adjust repair adjust replace replace replace replace repair replace |
| Brake pull |
1. Piston (Sticking) 2. Pad or lining (Oily) 3. Piston (Frozen) 4. Disc (Scored) 5. Pad or lining (Cracked or distorted) |
replace replace replace replace replace |
| Hard pedal but brake inefficient |
1. Brake system (Fluid leaks) 2. Brake system (Air in) 3. Pad or lining (Worn) 4. Pad or lining (Cracked or distorted) 5. Rear brake shoe clearance(Out of adjustment) 6. Pad or lining (Oily) 7. Pad or lining (Glazed) 8. Disc (Scored) 9. Booster system (Vacuum leaks) |
repair air·bleed replace replace adjust adjust replace replace repair |
| Noise from brake |
1. Pad or lining (Cracked or distorted) 2. Installation bolt (Loosen) 3. Disc (Scored) 4. Sliding pin (Worn) 5. Pad or lining (Dirty) 6. Pad or lining (Glazed) 7. Anchor or shoe (Faulty) 8. Brake pad shim (Damage) 9. Shoe hold-down spring (Damage) |
replace adjust replace replace clean replace replace replace replace |
| Brake fades |
1. Master cylinder (Inoperative) |
replace |
| Brake vibration, pulsation |
1. Brake booster (Vacuum leaks) 2. Pedal free play 3. Master cylinder (Inoperative) 4. Caliper (Damage) 5. Master cylinder cap seal 6. Damaged brake lines |
replace adjust replace replace replace replace |
| Brake Chatter |
Brake chatter is usually caused by loose or worn components,
or glazed or burnt linings. Rotors with hard spots can also contribute to
brake chatter. Additional causes of chatter are out-of-tolerance rotors,
brake lining not securely attached to the shoes, loose wheel bearings and
contaminated brake lining. |
Special Service Tools
Brake SystemDescription
The starting system includes the battery, starter, solenoid switch, ignition
switch, inhibitor switch (A/T), clutch pedal switch (M/T), ignition lock switch,
connection wires and the battery ...
Input Speed Sensor Removal
1.
Remove the valve body assembly.
(Refer to Hydraulic System - "Valve Body")
2.
Disconnect the input & output speed senso ...
Changing a tire with TPMS
If you have a flat tire, the Low Tire Pressure telltale will come on. Have the
flat tire repaired by an authorized Kia dealer as soon as possible or replace the
flat tire with the spare tire.
CAUTI ...