Kia Sorento: Troubleshooting - Engine Electrical System - Kia Sorento XM 2011-2024 Service ManualKia Sorento: Troubleshooting

Second Generation XM (2011-2024) / Kia Sorento XM 2011-2024 Service Manual / Engine Electrical System / Troubleshooting

Ignition System
Symptom
Suspect Area
Remedy
Engine will not start or is hard to
start (Cranks OK)
Ignition lock switch
Inspect ignition lock switch, or replace as required
Ignition coil
Inspect ignition coil, or replace as required
Spark plugs
Inspect spark plugs, or replace as required
Ignition wiring disconnected or broken
Repair wiring, or replace as required
Rough idle or stalls
Ignition wiring
Repair wiring, or replace as required
Ignition coil
Inspect ignition coil, or replace as required
Engine hesitates/poor acceleration
Spark plugs and spark plug cables
Inspect spark plugs / cable, or replace as required
Ignition wiring
Repair wiring, or replace as required
Poor mileage
Spark plugs and spark plug cables
Inspect spark plugs / cable, or replace as required

Charging System
Symptom
Suspect Area
Remedy
Charging warning indicator does not
 light with ignition switch "ON" and
 engine off.
Fuse blown
Check fuses
Light burned out
Replace light
Wiring connection loose
Tighten loose connection
Electronic voltage regulator
If light turns off, replace voltage regulator.
Charging warning indicator does not
go out with engine running. (Battery
requires frequent recharging)
Drive belt loose or worn
Adjust belt tension or replace belt
Battery cable loose, corroded or worn
Inspect cable connection, repair or replace cable
Electronic voltage regulator or alternator
If light turns off, replace voltage regulator or alternator
Wiring
Repair or replace wiring
Overcharge
Electronic voltage regulator
If light turns off, replace voltage regulator.
Voltage sensing wire
Repair or replace wiring
Discharge
Drive belt loose or worn
Adjust belt tension or replace belt
Wiring connection loose or short circuit
Inspect wiring connection, repair or replace wiring
Electronic voltage regulator or alternator
If light turns off, replace voltage regulator or alternator
Poor grounding
Inspect ground or repair
Worn battery
Replace battery

Starting System
Symptom
Suspect Area
Remedy
Engine will not crank
Battery charge low
Charge or replace battery
Battery cables loose, corroded or worn out
Repair or replace cables
Transaxle range switch
(Vehicle with automatic transaxle only)
Refer to AT group-automatic transaxle
Fuse blown
Replace fuse
Starter motor faulty
Replace
Ignition switch faulty
Replace
Engine cranks slowly
Battery charge low
Charge or replace battery
Battery cables loose, corroded or worn out
Repair or replace cables
Starter motor faulty
Replace
Starter keeps running
Starter motor faulty
Replace
Ignition switch
Replace
Starter spins but engine will not crank
Short in wiring
Repair or replace wiring
Pinion gear teeth broken or starter motor
Replace
Ring gear teeth broken
Replace fly wheel or torque converter

Special Service Tools
Tool (Number and name) Illustration Use Alternator pulley remover wrench (09373-27000) Removal and installation of alternator pulley ...

Ignition System
...

See also:

Inspection
1. Remove the cowl top cover. (Refer to the wiper) 2. Disconnect the windshield deicer connector (A) from the wiper motor linkage. ...

Interior B
* These dimensions indicated in this figure are actual-measurement dimensions. [ Unit : mm (inch) ] ...

Dynamic Damper Installation
1. Apply soap powder on the shaft to prevent being damaged between the shaft spline and the dynamic damper. 2. Install the dynamic damper. ...

Copyright В© www.ksmanual.com 2014-2024