1. |
Turn ignition switch OFF.
|
2. |
Remove the air duct.
(Refer to Engine Mechanical System - "Air cleaner")
|
3. |
Disconnect the solenoid valve connector (A).
|
4. |
Measure resistance between sensor signal terminal and sensor ground
terminal.
|
5. |
Check that the resistance is within the specification.
|
Replacement
Problems And Replacement Parts:
Problem
Part set
Scan tool required?
All keys have been lost
Blank key (4)
YES
Antenna coil unit does n ...
General
1.
Basically, all measurements in this manual are taken with a tracking
gauge.
2.
When a measuring tape is used, check to be sure there is ...
Blower Unit Components
1. Intake Case (LH)
2. Intake Case (RH)
3. Intake Door
4. Cowl Seal
5. NVH Seal
6. Blower Upper Case
7. Cluster Ionizer
8. Blower Lower Case
9. Power Mosfet (DAT ...