When replacing the TCM, the vehicle equipped with the immobilizer
must be performed procedure as below.
[In the case of installing used TCM]
[In the case of installing new TCM]
Perform "Key teaching" procedure with GDS.
(Refer to Body Electrical System - "Immobilizer System")
|
When replacing the TCM, the vehicle equipped with the smart key
system (Button start) must be performed procedure as below.
[In the case of installing used TCM]
[In the case of installing new TCM]
Insert the key (or press the start button) and turn it to the
IGN ON and OFF position. Then the TCM learns the smart key information
automatically.
|
1. |
Turn ignition switch OFF and disconnect the negative (-) battery
cable.
|
2. |
Disconnect the TCM Connector (A).
|
3. |
Remove the battery.
(Refer to Engine Electrical System - "Battery")
|
4. |
Remove the air cleaner assembly.
(Refer to Engine Mechanical System - "Air Cleaner")
|
5. |
Remove the mounting bolts (A) and nut (B), and then remove the
TCM (C).
|
6. |
After removing the installation nuts (A) and screws (B), remove
the TCM (C) from the bracket.
|
SRSCM Connector terminal
Pin
Function (Connector A)
Pin
Function (Connector B)
1
Ignition
1
Seat belt pretensioner [Driver] High
2
-
...
Removal
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Release the residual pressure in fuel line.
(Refe ...
Propeller Shaft Components
1. Front propeller shaft
2. Center bearing bracket
3. Rear propeller shaft
...