When the receiver first arrives for replacement:
|
It is important to make sure that the correct receiver is used
to replace the faulty part i.e. it must be Low Line (95800-1U00) in
order to have the correct inflation warning thresholds set.
|
1. |
Disconnect vehicle battery (-)cable.
|
2. |
Remove the glove box housing.
(Refer to Body - "Glove Box Housing")
|
3. |
Remove faulty part and fit bracket assembly to new part.
|
4. |
Secure new part to vehicle and fit connector.
|
5. |
Re-connect battery and turn Ignition on.
Vechicle Name Writing
VIN Writing
|
Engine start/stop button
Illuminated Engine Start/Stop button
Whenever the front door is opened, the ENGINE START/STOP button will illuminate
for your convenience.
The light will go off after about 30 seconds when the do ...
Replacement
Problems And Replacement Parts:
Problem
Part set
Scan tool required?
All keys have been lost
Blank key (4)
YES
Antenna coil unit does n ...
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the OCV connector.
3.
Measure resistance between the OCV termina ...