1. |
Wrap tape around the driveshaft spline(TJ) to prevent damage to
the boot.
|
2. |
Using the alignment marks (D) made during disassembly as a guide,
install the spider assembly (A) and retainer ring (B) on the driveshaft
splines (C).
|
3. |
Add specified grease to the joint boot as much as it was wiped
away at inspection.
|
4. |
Install the both boot band.
|
5. |
Using the SST(09495-3K000), secure the TJ boot bands.
|
6. |
Install the front driveshaft.
(Refer to Driveshaft Assembly - “Front Driveshaft”)
|
Crankshaft Components
1. Crankshaft upper bearing
2. Thrust bearing
3. Crankshaft
4. Crankshaft lower bearing
5. Main bearing cap
...
Speakers Replacement
Front Speaker
1.
Remove the front door trim.
(Refer to Body - "Front door")
2.
Remove the front speaker (A) after removing ...
Front Body E
* These dimensions indicated in this figure are actual-measurement
dimensions. [ Unit : mm (inch) ]
Hood hinge m ...