1. |
Remove the cylinder head cover.
(Refer to Cylinder Head Assembly - "Cylinder Head Cover")
|
2. |
Turn the crankshaft pulley and align its groove with the timing mark
of the timing chain cover to set the piston of No.1 cylinder to the
top dead center on compression stroke.
|
3. |
Remove the timing chain cover.
(Refer to Timing System - "Timing Chain Cover")
|
4. |
Make sure that the key (A) of crankshaft is aligned with the mating
surface of main bearing cap. As a result of this, the piston of No.1
cylinder is placed at the top dead center on compression stroke.
|
5. |
Release the ratchet by pulling the link down using a thin rod. Compress
the piston and then insert a stopper pin (A) into the hole on the ratchet
to hold the compressed piston. Remove the timing chain tensioner (B).
|
6. |
Remove the timing chain tensioner arm (A).
|
7. |
Remove the timing chain (A).
|
8. |
Remove the timing chain guide (A).
|
9. |
Remove the timing chain oil jet (A) and the crankshaft chain sprocket
(B).
|
10. |
Remove the balance shaft chain.
(Refer to Lubrication system - "Balance Shaft & Oil Pump")
|
Condenser Replacement
1.
Recover the refrigerant with a recovery/recycling/charging station.
2.
Disconnect the negative (-) battery terminal.
3.
...
Battery replacement
The transmitter uses a 3 volt lithium battery which will normally last for several
years. When replacement is necessary, use the following procedure.
1. Insert a slim tool into the slot and gently ...
Crankshaft Inspection
1.
Check the crankshaft bearing oil clearance.
(1)
To check main bearing-to-journal oil clearance, remove the main
caps and bearing ...