1. |
Disconnect the battery negative terminal.
|
2. |
Remove the fuse box cover.
|
3. |
Remove the starter relay(A).
|
4. |
Using an ohmmeter, check that there is continuity between each
terminal.
|
5. |
Apply 12V to terminal 85 and ground to terminal 86.
Check for continuity between terminals 30 and 87.
|
6. |
If there is no continuity, replace the starter relay.
|
7. |
Install the starter relay.
|
8. |
Install the fuse box cover.
|
Setup
Display Settings
Press the
key Select
[Display] through
TUNE knob or
key Select
menu through
TUNE knob
Mode Pop up
[Mode Pop up]
Changes selection mode
During On state, pr ...
Front Disc Brake Components
1. Guide rod bolt
2. Bleed screw
3. Caliper carrier
4. Caliper body
5. Inner pad shim
6. Brake pad
7. Pad retainer
...
Catalytic Converter Removal
1.
Remove the exhaust manifold.
(Refer to Engine Mechanical System - "Exhaust Manifold")
...