Kia Sorento: SRS Control Module (SRSCM) Removal - SRSCM - Restraint - Kia Sorento XM 2011-2024 Service ManualKia Sorento: SRS Control Module (SRSCM) Removal

Second Generation XM (2011-2024) / Kia Sorento XM 2011-2024 Service Manual / Restraint / SRSCM / SRS Control Module (SRSCM) Removal

1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least three minutes before beginning work.
3.
Remove the floor console.
(Refer to Body - "Floor console")
4.
Loosen the bolts and then remove the rear air vent duct (A).

5.
Pull up the lock of the SRSCM connector, the disconnect the connector (A).

6.
Remove the SRSCM mounting bolts(3EA) from the SRSCM, then remove the SRSCM.
  
You must remove or install SRSCM or other SRS components with the ignition swich OFF to avoid accidental airbag deployment.
SRS Control Module (SRSCM) Components
...

SRS Control Module (SRSCM) Installation
1. Remove the ignition key from the vehicle. 2. Disconnect the battery negative cable and wait for at least three minutes before beginning ...

See also:

Crankshaft Components
1. Crankshaft upper bearing 2. Thrust bearing 3. Crankshaft 4. Crankshaft lower bearing 5. Main bearing cap ...

Using the iPod® device
Some iPod® models may not support communication protocol and files may not properly play. Supported iPod® models: iPhone® 3GS/4 iPod® touch 1st~4th generation iPod® nano 1st~6th generation ...

Removal
1. Disconnect the negative (-) battery terminal. 2. Remove the steering column upper and lower shrouds (A) after removing 3 screws. ...

Copyright © www.ksmanual.com 2014-2024