Kia Sorento: Spark Plug Inspection - Ignition System - Engine Electrical System - Kia Sorento XM 2011-2024 Service ManualKia Sorento: Spark Plug Inspection

Second Generation XM (2011-2024) / Kia Sorento XM 2011-2024 Service Manual / Engine Electrical System / Ignition System / Spark Plug Inspection

[On vehicle inspection]
1.
Accelerate the engine to about 3,000 rpm 3 times or more.
2.
Remove the spark plug.
3.
Check the spark plug visually.
If the electrode is dry, the spark plug is normal.
If the electrode is wet, check the damage and electrode gap as below.
[Component Inspection]
1.
Check the spark plug for any damage on its thread and insulator.
If there is damage, replace the spark plug.
2.
Check the electrode. Measure the insulation resistance with an ohmmeter.
If the resistance is less than the specified value, adjust the electrode gap.

Specification: 10 MΩ or more

3.
Check the spark plug electrode gap.
If the gap is greater than the maximum, replace the spark plug.

Specification: 1.0 ~ 1.1 mm (0.0394 ~ 0.0433 in.)

  
•
If adjusting the gap of a new spark plug, bend only the base of the ground electrode. Do not touch the tip.
Never attempt to adjust the gap on a used plug.

Spark Plug Specification
Item Specification Type FXU16HR11 Gap 1.0 ~1.1 mm (0.0394 ~ 0.0433 in.) ...

Spark Plug Cleaning
The combustion temporarily becomes unstable, due to the aged fuel and the carbon deposits accumulated on the spark plug(s) after long-term storage. [1st Method] 1. ...

See also:

Smart key unit Components
Connector Pin Information No. Connector A Connector B Connector C 1 V_BAT load C_CAN Low SSB illumination ground 2 ...

Description
Back view camera will activate when the backup light is ON with the ignition switch ON and the shift lever in the R position. This system is a supplemental system that shows behind the vehic ...

Rear Door vReplacement
Door Trim Replacement    • When prying with a flat-tipped screwdriver, wrap it with p ...

Copyright © www.ksmanual.com 2014-2024