Be sure to install the harness wires not to be pinched or interfered
with other parts.
|
|
1. |
Remove the ignition key from the vehicle.
|
2. |
Disconnect the battery negative cable and wait for at least thirty
seconds.
|
3. |
Install the new seat back assembly. (Refer to the Body group-
Seat)
|
4. |
Install the front seat assembly. (Refer to the Body group- Seat)
|
5. |
Recline and slide the front seat forward fully, make sure the
harness wires are not pinched of interfering with other parts.
|
6. |
Reconnect the battery negative cable.
|
7. |
After installing the side airbag (SAB), confirm proper system
operation:
|
Hazard Lamp Switch Installation
1.
Install the heater control unit to the center fascia panel.
2.
Install the center fascia panel.
...
Front Washer Motor Removal
-
When servicing the washer pump, be careful not to damage
the washer pump seal.
...
Rear Driveshaft Inspection
1.
Check the driveshaft boots for damage and deterioration.
2.
Check the ball joint for wear and damage.
3.
Che ...