1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the center fascia panel (A).
(Refer to Body - "Crash pad")
|
3. |
Disconnect the connectors and cables (A) from center fascia panel.
|
4. |
Remove the driver and assist seat heater switch connector.
|
5. |
Check that continuity exists between the terminals after turning
the driver seat heater switch ON.
|
6. |
If the switch fails to operate, replace the driver and assist
seat heater switch (A).
|
1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the floor console rear cover (A).
(Refer to Body - "Console")
|
3. |
Turn 2nd seat heater switch ON and check that continuity exists
between the terminals.
|
4. |
Replace the 2nd seat heater switch.
|
Removal
1.
Remove the air duct.
(Refer to Engine Mechanical System - "Air cleaner")
2.
Remove the battery and the battery tray.
...
Removal
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Disconnect the purge control solenoid valve connector (A) ...
Description of ESC
Electronic Stability Control (ESC) recognizes critical driving conditions,
such as panic reactions in dangerous situations, and stabilizes the vehicle
by wheel-individual braking and engine c ...